![]() ![]() ![]() So the cause of the jam is due directly to the tabs that epson has in place to hold that black or brown arm in position. the arm will swing to open the area that is normally closed and will block the path of the switch. meaning the switch is not detecting the normal blocked state by the arm. When it swings the hall effect switch is open. One end goes to the main circuit board and controls a hall effect switch, the other end goes to the middle of the paper feed area and has a thin arm that sticks in between the rollers and it swings when paper is fed past it. The sensor works off of a small black or brown piece of plastic that runs across the back of the roller assembly that catches the edge of the paper to get it started into the carriage area. they have not allowed enough material to hold the paper jam detector in the correct position. ![]() it's a simple fix and it's due to epson's poor design. i also took pictures of the area that needs attention. i took it apart and found out exactly what is going on with these printers. In order to reconfigure the device quickly, make sure to write down the existing settings before performing re-initializing the interface.Epson xp300 paper jam every time even with no paper. Resetting your Epson printer to its default settings will remove any customizations that you have made to the print settings. Doing this will reset the device to its default settings.Ĩ Press and hold the "Status Sheet" button again to print a status sheet containing the device`s network information, including the IP address.ĩ Open a web browser, type your printer`s IP address in the address bar and press "Enter."ġ0 Select "Password" from the "Configuration - Optional" menu.ġ1 Leave the "Old Password" field blank, enter your new password in the "New Password" and "New Password (again)" fields and click "Apply." The devices must be powered on to access EpsonNet Config.Ģ Press and hold the red "Status Sheet" button on the back of the network interface device to print a status sheet containing the device`s network information, including the IP address.ģ Open a web browser, type your printer`s IP address in the address bar and press "Enter."Ĥ Select "Password" from the "Configuration - Optional" menu.ĥ Enter your existing password in the "Old Password" field, enter your new password in the "New Password" and "New Password (again)" fields and click "Apply."Ħ Turn on your printer and network interface device and wait until the status light and data light turn off.ħ Press and hold the red "Status Sheet" button on the back of the network interface device until the green light flashes and turns on. ![]() 1 Turn on the printer and network interface device. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |